Here's my comparison between inline amplifier and LNA4ALL range wise.
Same antenna and same SAT-diplexer as a "filter" in both.
Inline amplifier max range in south 138nm and in north 68nm
LNA4ALL max range in south 182nm and in north 113nm
Also with LNA4ALL I have almost doubled reported...
I have. My location currently is very much blocked, antenna is in my balcony which is facing south, and there's trees just front so I can't really see much sky. That's why my max range is without amp 100nm, with amp & two way splitter 140nm. With LNA4ALL (which got burned somehow, waiting for...
Thanks for the tip.
You were right that with a diplexer it didn't work.
But I found a 2 way splitter with power pass on both ports, 5-2500MHz, and it seems to work. Without amp my antenna was picking 0 planes, but when I put amp, instantly picked a plane and dump1090-muta show's RSSI around -3...
Would a sat diplexer work as a power inserter for amplifier? Like this: 18V power supply -> diplexers power pass port -> coax to amplifier -> antenna?
I can't find a power inserter with a reasonable price and postage anywhere, but those diplexers are so cheap and available everywhere.
It seems tht adsb-polar-2.py stops when there's 0 aircrafts active. Is there a workaround to keep it recording? When started again it seems to delete earlier positions and start over.
Active aircraft: 1 Update rate: 0.6/s
Active aircraft: 1 Update rate: 0.1/s
Traceback (most recent call...
I'm getting an error during install when it's creating graphs. All other graphs works, but don't see the max range graph at all.
===== Finished webUI installation, creating initial graphs! =====
12483 (process ID) old priority 0, new priority 5