Read the help!
-h [ --help ] This help message
--device-list List Available devices
--device-index arg Select RTL device (default: 0)
--device-serial arg Select RTL device by serial...
Make the following correction:
'--agc' has no arguments, so remove the "on",
"--sbs 10001" is incorrect. Should be '--sbs10001 10001'.
'--rbs' has no arguments, so remove the "on"
So, use this:
cmd /c modesdeco2.exe --gain 49.6 --freq-correction 62 --agc --location 4.1893:89.5660 --web 8088...
Write your full command line options that uses for starts the program.
By the pieces of log can say that program is trying to connect on the same computer. But it can't. It is not clear why changing the port.
So, need your full command line options or content of the modesdeco2.bat file.
Optimal in the meaning that is most suitable for your particular antenna-feeder device.
the "--gain" there is no overloading by input signal level. Set the maximum, i.e., 49.6 dB. Typically, the program will automatically adjust this value later.
the "--freq-correction" is the...
There are three possible variants to add source of pictures.
1. Images can be placed on the same computer where the program runs. Just put their into existing subdirectory pictures which is inside the static folder:
No options are required:
acarsdeco2 --gain 38.6...
The computer resources are insufficient, especially its processor. For example, this happens when for the SDR computer you use low-powered laptop or netbook.
Or is enabled lowering the CPU frequency, in battery saving mode where the CPU is slow. It doesn’t happen in normal mode.
The option --rbs has no additional arguments. It's switcher, which only enables or disables the decoding mode of signal Mode A/C. Use this option only if you are really sure you need this data. Otherwise, it only makes additional CPU loading and clutters up output stream.
+ added support for AirSpy receivers (Firmware Version: Base AirSpy NOS v1.0.0-rc4-0-g23d1436 2015-03-22 and special AirSpy NOS v1.0.0-rc3-2-g23d1436-dirty 2015-03-22) with Intel x86 CPU (Windows, Linux, OS X)
+ added option --airspy-sr <arg> Set AirSpy sample rate...
It seems to me that I don't fully understand your question.
The program itself has no GUI (if the GUI imply graphical user interface), since it is a console application.
The internal web server is activated by adding the option "--web" with the value of HTTP port number. And subsequent opening...
Test version of modesdeco2 with hackRF support was implemented in September 2014. However, it was not publicly released. The first implementation did not show clear advantages over RTL dongle and needs to be improved decoding algorithm, specific for hackRF.
Now it is declared as a test version, but if passes all functions well, then becomes the release of ModeSMixer2 20150220.
+ fixed some bugs
+ added interpretation of airport codes on route. To see, place cursor in rotation on the ICAO airport codes
+ added second table on Google map...