I
I receive this screen in Windows PowerShell even when I run PowerShell as an administrator during setup of PlaneFinder Client. I cannot proceed with setup until I Windows 10 can find PlaneFinder Client. Error 404 indicates a broken link or inability to find the server. I am guessing I need a link that works. Any advice from someone would be most appreciated.
Error 404 during PlaneFinder Client setup.
- Thread starter thehook
- Start date
That is a very old version of the client - no longer supported. Out of interest where did you find the information for that?
The newest version can be obtained from here:
planefinder.net
The newest version can be obtained from here:
ADS-B Client - Plane Finder
The Plane Finder ADS-B Client is the easiest and most accurate way to share your ADS-B and MLAT data.
planefinder.net
Can you post a link to the page please as I’d like to get that removed.
The link I used is found on and highlighted under the heading "Installation and Configuration".
I downloaded these installation instruction directly from PlaneFinder.
Thank you,
I just followed that link and it's the same as the one I sent you. No mention of "npm install" at all. Do you know where you found that instruction?
Thanks!
I just followed that link and it's the same as the one I sent you. No mention of "npm install" at all. Do you know where you found that instruction?
Thanks!
